How to solve the whitening and bubbling of acrylic sheet bonding?

Jun 23, 2025

Leave a message

Before the formal bonding operation, be sure to use alcohol to acrylic sheet, such as 3mm clear acrylic sheet, 5mm clear acrylic sheet, 3 mm acrylic sheet bonding surface for careful cleaning.

 

Alcohol is highly effective in dissolving and removing oils, dirt and impurities on the surface of acrylic sheets. The principle lies in the molecular structure of alcohol and oil and other impurities have a certain affinity, through the intermolecular force will be these impurities from the surface of the acrylic board stripped. After alcohol clean surface, for glue and acrylic board to achieve quality bonding between the clean and ideal foundation. If there is oil or dust and other pollutants on the surface of the acrylic sheet, the molecules of the glue will be difficult to form a close and effective contact with the molecules of the acrylic sheet, and then can not achieve sufficient chemical crosslinking and physical adsorption, which is not only easy to produce bubbles in the adhesive, but also lead to a significant reduction in the strength of the bond, which seriously affects the quality and service life of acrylic products. In the cleaning operation, it is recommended to use fine texture, absorbent clean cotton cloth or non-woven cloth as a wiping tool.

 

Appropriate amount of alcohol evenly dipped in the cloth, with a gentle and stable force, in accordance with the same direction to slowly wipe the adhesive surface of the acrylic board. Wiping process need to pay close attention to the surface condition, continue to wipe until the surface presents a clean, no impurities left in the state.

 

In the gluing process, the operator should be uniform, smooth to promote the scraper, so that the glue on the surface of the acrylic board evenly distributed. For a large area of bonding surface, in order to ensure the consistency of the quality of the glue, can be used to gradually apply the strategy of subarea glue. First of all, the bonding surface is divided into a number of relatively small areas, in accordance with a certain order of each area in turn for the gluing operation, in each area, are required to strictly follow the principle of uniform speed to promote the scraper, control the thickness of the glue.

 

Finish applying glue and the bonding surface of the two acrylic panels aligned fit, you need to first light pressure on the bonding surface, so that the glue is evenly filled between the two bonding surfaces, and most of the air is discharged. After light pressure, the bonded acrylic board will be static, and then placed on top of the weight pressure, for 24 hours, so that the operation is complete.